Installation Guide
GRACY™ RGS 560×260-12 LED luminaire
Content
Components
GRACY™ RGS Light Panel
Power Supply (PSU)
Screws
Metal washers
Rubber washers
Screw Sockets
Prepararing installation
IMPORTANT NOTICE:
- Use ONLY 24 VDC constant current PSU/Driver
- The LED’s in this LED panel cannot be replaced.
- The LED panel must be installed in accordance with all applicable building regulations.
- At the end of use, the light panels must be treated as electrical scrap and disposed of in accordance with applicable regulations.
Establish a suitable supporting structure so that it is possible to mount the LED panel using the predrilled mounting holes.
NOTE:
All 230 VAC wiring must be installed and connected by an authorized electrician.
Adjusting PSU output current
The output current must be adjusted on the 24VDC constant current PSU to fit desired light level.
Recommended current values
(GRACY RGS 560×260-12)
NOTE:
SWITCH ON the 230VAC power at the circuit breaker.
Installing cables, PSU‘s & boxes
- Route cables and mount PSUs and electric boxes to connect LED panels.
- All cables between the light panel and the PSU must be properly secured to the structure.
NOTE:
SWITCH OFF the 230VAC power at the circuit breaker.
CAUTION:
If cables pass through holes in metal or over sharp edges that can damage the cable insulation.
These places must be fitted with cable grommets.
Wiring Diagram
Mounting of PSU’s
Ensure good ventilation around PSU
– 10 cm clearance on all sides.
NOTE:
DO NOT mount PSU on the LED panel.
Mounting GRACY™ SQR light panels
Lift the LED panel up to the supporting structure.
Fasten the LED panel to the structure, using the supplied screws, washers and sockets.
NOTE:
DO NOT drill or screw into the LED panel.
If the DALI PSU is used, connect signal conductors to the DALI terminals of the power supply.
Connecting GRACY™ light panels to PSU (24VDC)
Connect the LED panel cable to the secondary side (Output) of the PSU (DC):
- Connect RED wire from light panel to PSU wire (+)
- Connect BLACK wire from light panel to PSU wire (–)
CAUTION:
Be carefull to connect power cord correctly (Observe polarity)
If the DALI PSU is used, connect signal conductors to the DALI wires on the PSU.
Support
We trust the installation of our GRACY™ product went well.
For more gudelines, please visit:
If you need further support you can contact our customer service team at
sales@ledibond.com or call +45 7070 7855